24/7 Free Online Support all over India | Guranteed Lowest Price | All over India Shipping

Visit Our Online Store :
techfinder: Best place for women ethnic apparel Shopping
/  /  /  Teltonika FMB920 GPS Vehicle Tracker

Teltonika FMB920 GPS Vehicle Tracker

  • (0)
  • See All Review
  • Wishlist
7,507 8,999 17% Off
SKU : FMB920

BASIC information

This message contains information on how to operate FMB920 safely. By following these requirements and recommendations, you will avoid dangerous situations. You must read these instructions carefully and follow them strictly before operating the device!

  • he device uses SELV limited power source. The nominal voltage is +12 V DC. The allowed voltage range is +6...+30 V DC.
  • To avoid mechanical damage, it is advised to transport the device in an impact-proof package. Before usage, the device should be placed so that its LED indicators are visible. They show the status of device operation.
  • When connecting the connection (1x5) cables to the vehicle, the appropriate jumpers of the power supply of the vehicle should be disconnected.
  • Before dismounting the device from the vehicle, the 1x5 connection must be disconnected.
  • The device is designed to be mounted in a zone of limited access, which is inaccessible to the operator. All related devices must meet the requirements of EN 62368-1 standard.
  • The device FMB920 is not designed as a navigational device for boats

Mounting recommendations

Connecting Wires

  • Wires should be fastened to the other wires or non-moving

parts. Try to avoid heat emitting and moving objects near
the wires.

  • The connections should not be seen very clearly. If factory

isolation was removed while connecting wires, it should be
applied again.

  •  If the wires are placed in the exterior or in places where they

can be damaged or exposed to heat, humidity, dirt, etc.,
additional isolation should be applied.

  • Wirescannotbeconnectedtotheboardcomputersor
    control units. 

Connecting power source

  • Be sure that after the car computer falls asleep, power is still available on chosen wire. Depending on car, this may happen in 5 to 30 minutes period.
  • When module is connected, measure voltage again to make sure it did not decrease.
  •  It is recommended to connect to the main power cable in the fuse box.
  • Use 3A, 125V external fuse.
:
Download PDF File:
↑